How to reduce variability of solar power energy supply

The Earth’s surface in sunlight in ideal conditions gets about 255 x 1011 W/m2. More than enough to power multiple countries. But, when that side of the earth is pointing away from the Sun, the energy drops to zero. To depend on solar power, there must be a substitute or storage option for that loss.

Solution
There must be a Planetary Power Grid. The active surface of the planet must supply a percentage of its power generation to the opposite side. The science and engineering of power grids are well understood. They just have to be bigger and more efficient, such as using superconducting cables, space based solar power, and microwave power relay stations.

This power grid will supply power to where it is most needed. A portion of the available energy is used to supply energy storage facilities in regions that have reduced economic activity due to the day/night cycle.

To be feasible, more sunlight capture and higher efficient voltaic generators are required. Until that can be accomplished: fossil, nuclear, wind, and other supplies will make up the difference.

This is huge task and a host of hurdles like technological, political, economic, and logistics. The cost is in the trillions. But, if the tipping point of climate change is approaching, nickle-and-dime approaches are not realistic. This really does requires a Green New Deal but for multiple countries to take part.

Estimated completion for total globe: 2053.

Increasing the irradiated solar cell area
Solar farms should be in the ocean. These are a mix of fixed offshore solar farms and floating Sun tracking systems.

When they are in the ocean the water could also be used for cooling and cleaning of the solar arrays. But this location must be engineered to have minimal negative ecological effects. Note that marine life does depend on solar energy. Blocking of sunlight would upset fragile oceanic ecologic systems and any kind of tower could impact bird migration patterns.

Other renewable
This same “MegaGrid” could be used for distribution of other energy sources like wind turbine, tidal, etc.

My calculation.
It’s just a simple multiplication of surface area by the energy density.
The surface area of the earth illuminated by the sun is approx 255,000,000 km2. That is just half of the total spherical area. The Sun’s energy at ground level is 1,000 W/m2.
So, that is 255,000,000,000 kW/m2 potentially available energy. Or, 255×10(11)W/m2.

After writing the above I did more web searching. Not a new concept after all! For example “Let’s Build a Global Power Grid”, https://spectrum.ieee.org/energy/the-smarter-grid/lets-build-a-global-power-grid

How a power grid works

Courtesy of: Visual Capitalist

Links

Creative Commons License
How to reduce variability of solar power energy supply by Josef Betancourt is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Leave a Reply

Your email address will not be published. Required fields are marked *